The Opticon MEK-3100 kit is all you need to kick-start your project with Opticon scan engines. This kit is designed to make the testing process much easier. Except for the scan engine itself this kit contains all the hardware that you need to get started. This kit is designed to make the laborious testing process a little easier.
The MEK-3100 scan engine development kit contains the following items:
- FFC cable with contacts on the opposite sides
- FFC cable with contacts on the same side
- RS-232 interface cable
- USB interface cable
- AC adapter with international power plugs
- 2 screws M2x5
- 4 PCB standoffs
The scan engine(s) to be tested need to be ordered separately!
Properties
- MDC-100/MDC-200
- MDI-3100
- MDI-4100
- MDL-1500
Physical
Physical connections:
USB type connections (most common):
subD9 type serial/RS232C connections:
a D9 connector has a 9 pins (or lines)
RJ45 type serial/RS232C connection:
an RJ45 connector has a 8 pins (or lines)
RJ45 type ethernet connection:
an RJ45 connector has a 8 pins (or lines)
RJ50 PIGTAIL type connection:
an RJ45 connector has a 8 pins (or lines)
Pigtail means the cable runs from the device ending in a connector.
- FLAT cable